The Way To Spray Latex Paint

The Way To Spray Latex Paint

The fastest way to get the smoothest end with latex paint is to make use of an airless paint sprayer, which you may lease for less than $a hundred a day. (Other sprayers are less expensive but require you to thin the paint to a precise consistency.) As you comply with these spraying guidelines, remember to wear a disposable respirator and cover anything within the vicinity that you do not need paint droplets to land on.

Prime the sprayer. Match the gun with the proper-sized tip (see TOH Tip, beneath). Then stick the sprayer's siphon tube in a clean bucket of paint, and fill the sprayer, hose, and gun in keeping with the instruction manual.

Set the pressure. Turn the sprayer's pressure-­adjustment knob to the lowest setting recommended by the paint manufacturer. Hold the gun 12 to 14 inches away from a scrap piece of cardboard or paper and spray a test line with one uniform stroke of your arm. If the paint spits out of the gun or two thin lines seem above and below the principle stream, the pressure is just too low. Flip the knob up slightly and test-spray one other line. If the coverage is just too light or there is a lot of overspray, the pressure is simply too high. The pressure is just right when the paint flows evenly out of the gun in a single stream.

Spray the edges. Hold the gun tip 12 to 14 inches away from and perpendicular to the edge. Apply the spray in one fluid motion in order that an equal amount of spray goes past the highest and backside edges, as shown above.

Spray the faces. Hold the gun tip 12 to 14 inches away from and perpendicular to the face of the door or cabinet frame. Using the same smooth, uniform motion as above, overlap every pass by 50 percent. Flush out the sprayer. On the finish of each day's spray­ing session, remove and brush-clean the gun's tip and spray guard. Stick the siphon tube in a bucket of clean water, and pump the water by way of the sprayer, hose, and gun right into a waste bucket, based on the instructions within the manual. Proceed flushing until only clear water comes out.

TOH Tip: You'll find the specs for a gun's tip dimension and sprayer pressure for the paint you need to use within the technical data sheets on the manufacturer's website.

If you beloved this article therefore you would like to get more info pertaining to latex spuitwerk kindly visit our internet site.
   
© Copyright 2013